Mobotix D24M Manual page 63

D24 Camera-Manual: InSTALLATIOn
Use the fold-out template included at the end of the printed manual (valid for both
0° and 10° On-Wall Sets).
Make sure that the drilling template is not scaled or adjusted to the paper size when
printing the PDF file (enlarged or reduced).
The maximum torque for all screws is 1 to 1.2 Nm.
Scope Of Delivery And Required Parts
Please first check that all components supplied with the On-Wall Set are present in the
original packaging.
The Following Additional Tools Are Required For Installation:
• Suitable materials for ceiling/wall installation: 4 screws incl. screw anchors and
washers (e.g. from the original camera packaging).
• Screwdriver
• Power drill for screw anchor holes needed for ceiling/wall mounting
• MOBOTIX drilling templates (at the end of this manual)
• Scissors to cut out the template
• Pen to mark the drill holes
• Materials and tools needed to connect the pre-installed MOBOTIX network cable in
the camera with the on-site network cable
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
Notes
63
/133