Mounting With The Wall Mount - Mobotix D71 Quick Installation Manual

Mounting
Mounting Options
6. Place the In-Ceiling Set in the ceiling opening and tighten the dovetail guides clockwise using a Phillips
screwdriver.
7. Push the rubber plugs
8. Connect the camera to the PoE network connection of the building (see
Network, p. 55).

Mounting with the Wall Mount

CAUTION! Before mounting the camera, make sure that a network connection with power supply according
to the PoE Plus (802.3at-2009) standard is available at the mounting position (see
to the Network).
The Wall Mount allows you to easily mount the MOBOTIX D71 to walls or extensions, indoors and outdoors.
The camera remains IP65 weatherproof (dust-proof and resistant to water jets). The Wall Mount also covers
RJ45 wall outlets and has ample space for additional modules (WiFi, batteries, etc.).
Before mounting the MOBOTIX D71 with the Wall Mount, drill the holes for the fixtures. You can use the sup-
plied drilling template (see
NOTE! Download the drilling template from the MOBOTIX website:
load Center > Marketing & Documentation > Drilling
CAUTION! Always print or copy the drilling template at 100% of the original size!
NOTE! Do not use the dowels if the installation surface is wood. Only use the screws to fasten the mounting
plate directly on the surface. In order to facilitate screwing in wood, the positions should first be pre-drilled
using a 2 mm drill bit, for example (drilling depth just slightly less than screw length).
46 / 72
M.7, p. 19 into the screw holes of the camera.
Drilling Template as PDF.
Connecting the Camera to the
www.mobotix.com > Support > Down-
Templates.
Connecting the Camera