Figure 189: Snmp Traps - D-Link DWC-1000 User Manual

Wireless Controller

Figure 189: SNMP Traps

AP Failure Traps: If you enable this field, the SNMP agent sends a trap if an AP fails
to associate or authenticate with the controller.
AP State Change Traps: If you enable this field, the SNMP agent sends a trap for one
of the following reasons, each containing location objects:

Managed AP Discovered

Managed AP Failed

Managed AP Unknown Protocol Discovered.

Managed AP Load Balancing Utilization Exceeded.
Client Failure Traps: If you enable this field, the SNMP agent sends a trap with failure
info for clients authenticated by AP's managed by the controller, with each trap
containing location objects:
325
User Manual