D-Link DSN-610 Quick Installation Manual
Iscsi ip san storage, 1gbe/ 10 gbe iscsi to sata / sas raid controller
Hide thumbs
Also See for DSN-610:
- Quick installation manual (32 pages) ,
- Brochure & specs (7 pages) ,
- Quick installation manual (40 pages)
Related Manuals for D-Link DSN-610
Summary of Contents for D-Link DSN-610
- Page 1 D-Link iSCSI IP SAN storage DSN-610/ DSN-640 1GbE/ 10 GbE iSCSI to SATA / SAS RAID controller Quick Installation Guide Version 1.0 (April, 2011) D-Link Corporation http://www.dlink.com...
-
Page 2: Package Contents
Package contents The package contains the following items: RAID controller, DSN-610 or DSN-640 (x1) GBIC transceiver (x1) and cable (x1) for DSN-640 only Install battery backup module Please follow procedure below to install battery backup module. Make sure DSN-6000 series is power off. - Page 3 Install DSN-610/DSN-640 in DSN-6x10 subsystem This following procedure applies to upgrading from DSN-6110 to DSN6120 as well as from DSN-6410 to DSN-6420. Before you do this, please make sure that either DSN-6110 or DSN-6410 is properly installed according to the manuals.
- Page 4 Please follow the steps below to upgrade to dual controller mode. Step 1 Go to “Maintenance\System”. Copy the IP SAN storage serial number. Step 2 Go to “Maintenance\Upgrade” and paste the serial number into “Controller Mode” section. Select “Dual” as operation mode.
- Page 5 Step 3 Click “confirm”. The system will ask you to shutdown. Please shutdown IP SAN storage. Click Ok.
- Page 6 Go to “Maintenance\Reboot and shutdown”. Click “Shutdown” to shutdown the system. Click Ok.
- Page 7 Step 4 Power off DSN-6110 or DSN-6410 by switching power button. Remove the empty cage by loosen the screws and ejection levers. Screws& ejection levers Power switch Step 5 Insert the second controller to the IP SAN storage and secure in place, then power on the system.
-
Page 8: Revision History
Revision history Date Version Owner Description 2011/04/29 Initial version...