D-Link DWC-1000 User Manual page 279

Wireless Controller
User Manual
DNS Suffix: The DNS suffix name which will be given to the SSL VPN client. This
configuration is optional.
Primary DNS Server: DNS server IP address to set on the network adaptor created on
the client host. This configuration is optional.
Secondary DNS Server: Secondary DNS server IP address to set on the network
adaptor created on the client host. This configuration is optional.
Client Address Range Begin: Clients who connect to the tunnel get a DHCP served IP
address assigned to the network adaptor from the range of addresses beginning with
this IP address
Client Address Range End: The ending IP address of the DHCP range of addresses
served to the client network adaptor.
Setup > VPN Settings > SSL VPN Client > Configured Client Routes
If the SSL VPN client is assigned an IP address in a different subnet than the corporate
network, a client route must be added to allow access to the private LAN through the
VPN tunnel. As well a static route on the private LAN's firewall (typically this
controller) is needed to forward private traffic through the VPN Firewall to the remote
SSL VPN client. When split tunnel mode is enabled, the user is required to configure
routes for VPN tunnel clients:
Destination Network: The network address of the LAN or the subnet information of
the destination network from the VPN tunnel clients' perspective is set here.
Subnet Mask: The subnet information of the destination network is set here.
278