Manual Power Adjustment Plan - D-Link DWC-1000 User Manual

Wireless Controller

5.2.4 Manual Power Adjustment Plan

Setup > AP Management > RF Management > Manual Power Adjustment
Plan
If you select Manual as the Power Adjustment Mode on the Configuration tab, you
can manually initiate the power adjustment algorithm on the Manual Power
Adjustments page.
Current Status: Shows the Current Status of the plan, which is one of the
following states:






AP MAC address:
Location: Identifies the location of the AP, which is set in the Valid AP database.
Radio Interface: Identifies the radio.
Old Power: Shows the earlier power level for the AP.
New Power: Shows the proposed power level for the AP.
The following actions are supported from this page:
Start: To initiate the power adjustment algorithm.
None: The power adjustment algorithm has not been manually run since
the last controller reboot.
Algorithm In Progress: The power adjustment algorithm is running.
Algorithm Complete: The power adjustment algorithm has finished
running.
A table displays to indicate proposed power adjustments. Each entry
shows the AP along with the current and new power levels.
Apply In Progress: The controller is adjusting the power levels that the
APs use.
Apply Complete: The algorithm and power adjustment are complete. AP
MAC Address Identifies the
Identifies the AP MAC address.
163
User Manual