Figure 162: Ssl Vpn Client Adapter And Access Configuration - D-Link DWC-1000 User Manual

Wireless Controller

The IP addresses of the client's network interfaces (Ethernet, Wireless, etc.)
cannot be identical to the controller's IP address or a server on the corporate
LAN that is being accessed through the SSL VPN tunnel.

Figure 162: SSL VPN client adapter and access configuration

The controller allows full tunnel and split tunnel support. Full tunnel mode just sends
all traffic from the client across the VPN tunnel to the controller. Split tunnel mode
only sends traffic to the private LAN based on pre -specified client routes. These client
routes give the SSL client access to specific private networks, thereby allowing access
control over specific LAN services.
Client level configuration supports the following:
Enable Split Tunnel Support: With a split tunnel, only resources which are referenced
by client routes can be accessed over the VPN tunnel. With full tunnel support (if the
split tunnel option is disabled the DWC-1000 acts in full tunnel mode) all addresses on
the private network are accessible over the VPN tunnel. Client routes are not r equired.
277
User Manual