6To4 Tunneling - D-Link DWC-1000 User Manual

Wireless Controller
User Manual
value must be the same for all routers attached to a common network. The default value
is 10 seconds.
DeadInterval: The number of seconds that a device's hello packets must not have been
seen before its neighbors declare the OSPF router down. This value must be the same
for all routers attached to a common network. The default value is 40 seconds. OSPF
requires these intervals to be exactly the same between two neighbors. If any of these
intervals are different, these routers will not become neighbors on a particular segment
Cost: The cost of sending a packet on an OSPFv2 interface.
Authentication Type: This column displays the type of authentication to be used for
OSPFv2.If Authentication type is none the interface does not authenticate OSPF
packets. If Authentication Type is Simple then OSPF packets are authenticated using
simple text key.If Authentication Type is MD5 then the interface authenticates OSPF
packets with MD5 authentication.
Authentication Key: Assign a specific password to be used by neighboring OSPF
routers on a network segment that is using Authentication. Routers in the same area that
want to participate in the routing domain will have to be configured with the same key.
Md5 Key Id: Input the unique MD-5 key ID to be used by neighboring OSPF routers on
a network segment that is using Authentication. Type as MD5
Md5 Authentication Key: Input the authentication key for this MD5 key to be used by
neighboring OSPF routers on a network segment that is using Authentication Type as
MD5
6.6

6to4 Tunneling

Advanced > IPv6 > 6to4 Tunneling
6to4 is an Internet transition mechanism for migrating from IPv4 to IPv6, a system that
allows IPv6 packets to be transmitted over an IPv4 network . Select the check box to
Enable Automatic Tunneling and allow traffic from an IPv6 LAN to be sent over a
IPv4 Option to reach a remote IPv6 network.
200