Figure 106: Protocol Binding Setup To Associate A Service And/Or Lan Source To An Option And/Or Destination Network - D-Link DWC-1000 User Manual

Wireless Controller
Advanced > Routing > Protocol Bindings
Protocol bindings are required when the Load Balancing feature is in use. Choosing
from a list of configured services or any of the user -defined services, the type of
traffic can be assigned to go over only one of the available Option ports. For increased
flexibility the source network or machines can be specified as well as the destination
network or machines. For example the VOIP traffic for a set of LAN IP addresses can
be assigned to one Option and any VOIP traffic from the remaining I P addresses can
be assigned to the other Option link. Protocol bindings are only applicable when load
balancing mode is enabled and more than one Option is configured.
Figure 106: Protocol binding setup to associate a service and /or LAN
source to a n Option and/or destination network
Service: Select one of the various services available for protocol binding
Local Gateway: select the port that sets the local gateway for this protocol
binding (either option1 or option2)
Source Network: Select one of the following:
Any: No specific network needs to be given.
191
User Manual