D-Link DWC-1000 User Manual page 122

Wireless Controller
Radio: Shows the wireless radio mode the AP is using.
Channel: Shows the operating channel for the radio.
The following actions are supported from this page
Delete All: Manually clear all APs from the All Access Points status page except
Managed Access Points.
Manage: Configure an Authentication Failed AP to be managed by the controller
the next time it is discovered. Select the check box next to the MAC address of the
AP before you click Manage You will be presented with the Valid Access Point
Configuration page. You can then configure the AP and click Submit to save the AP
in the local Valid AP database. If you use a RADIUS server for AP validation, you
must add the MAC address of the AP to the AP database on the RADIUS server.
Acknowledge: Identify an AP as an Acknowledged Rogue. Select the check box next
to the MAC address of the AP before you click Acknowledge. The controller adds
the AP to the Valid AP database as an Acknowledged Rogue.
View Details: To view the details configured APs. Select the check box next to the
MAC address of the AP before you click View Details.
Refresh: Updates the page with the latest information
•
Managed: The AP profile configuration has been applied to the AP
and it's operating in managed mode.
•
No Database Entry: MAC address of the AP does not appear in the
local or RADIUS Valid AP database.
•
Authentication (Failed AP): The AP failed to be authenticated by
the controller or RADIUS server. Since AP is not configured as a
valid AP which the correct local or RADIUS authentication
information.
•
Failed: The controller lost contact with the AP; a failed entry will
remain in the managed AP database unless you remove it. Note that a
managed AP will temporarily show a failed status during a reset.
•
Rogue: The AP has not attempted to contact the controller and the
MAC address of the AP is not in the Valid AP database.
121
User Manual