Lan Configuration In An Ipv6 Network; Figure 6: Lan Dhcp Pool Configuration - D-Link DWC-1000 User Manual

Wireless Controller

Figure 6: LAN DHCP Pool configuration

Once confirgured, the list of DHCP Pools at the bottom of the LAN Setup
Configuration page (Figure 3) is updated with the new pool range.

2.1.4 LAN Configuration in an IPv6 Network

Advanced > IPv6 > IPv6 LAN > IPv6 LAN Config
In IPv6 mode, the LAN DHCP server is enabled by default (similar to IPv4 mode).
The DHCPv6 server will serve IPv6 addresses from configured address pools with the
IPv6 Prefix Length assigned to the LAN.

IPv4 / IPv6 mode must be enabled in the
mode
LAN IP Address Setup
The default IPv6 LAN address for the router is fec0::1. You can change this 128 bit
IPv6 address based on your network requirements. The other field that defines the
LAN settings for the router is the prefix length. The IPv6 network (subnet) is
identified by the initial bits of the address called the prefix. By default this is 64 bits
long. All hosts in the network have common initial bits for their IPv6 address; the
number of common initial bits in the network's addresses is set by the prefix length
field.
to enable IPv6 configuration options.
23
User Manual
Advanced > IPv6 > Routing