Static Routing - D-Link DWC-1000 User Manual

Wireless Controller
If RIP-2B or RIP-2M is the selected version, authentication between this controller
and other controllers (configured with the same RIP version) is require d. MD5
authentication is used in a first/second key exchange process. The authentication key
validity lifetimes are configurable to ensure that the routing information exchange is
with current and supported controllers detected on the LAN.

6.4.3 Static Routing

Advanced > Routing > Static Routing
Advanced > IPv6 > IPv6 Static Routing
Manually adding static routes to this device allows you to define the path selection of
traffic from one interface to another. There is no communication between this
controller and other devices to account for changes in the path; once configured the
static route will be active and effective until the network changes.
The List of Static Routes displays all routes that have been added manually by an
administrator and allows several operations on the static routes. The List of IPv4
Static Routes and List of IPv6 Static Routes share the same fields (with one
exception):
Name: Name of the route, for identification and management.
Active: Determines whether the route is active or inactive. A route can be added to
the table and made inactive, if not needed. This allows routes to be used as needed
without deleting and re-adding the entry. An inactive route is not broadcast if RIP is
enabled.
Private: Determines whether the route can be shared with other controllers when RIP
is enabled. If the route is made private, then the route will not be shared in a RIP
broadcast or multicast. This is only applicable for IPv4 static routes.
Destination: the route will lead to this destination host or IP address.
IP Subnet Mask: This is valid for IPv4 networks only, and identifies the subnet that
is affected by this static route
Interface: The physical network interface (Option1, Option2, DMZ or LAN), through
which this route is accessible.
196
User Manual