B-Pillar Lower Trim Removal; Installation; B-Pillar Upper Trim Removal; Cross Car Beam Removal - Chrysler 300M Service Manual

23 - 62 INTERIOR
B-PILLAR LOWER TRIM
REMOVAL
(1) Remove seat belt height adjuster knob.
(2) Remove upper B-pillar trim.
(3) Remove bolt attaching seat belt to floor below
B-pillar (Fig. 4).
(4) Remove access door from above seat belt slot
on B-pillar trim.
(5) Disengage clips attaching lower trim to B-pil-
lar.
(6) Slide seat belt through the B-pillar trim.
(7) Remove B-pillar trim from vehicle.
Fig. 4 B-PILLAR LOWER AND UPPER TRIM
1 - SHOULDER HARNESS ADJUSTER
2 - UPPER B-PILLAR TRIM
3 - CLIPS
4 - LOWER B-PILLAR TRIM
5 - B-PILLAR
6 - CLIP

INSTALLATION

(1) Slide seat belt through the B-pillar trim.
(2) Place B-pillar trim in position on vehicle.
(3) Engage clips attaching lower trim to B-pillar.
(4) Install access door above seat belt slot on B-pil-
lar trim.
(5) Install bolt attaching seat belt to floor below
B-pillar.
(6) Install upper B-pillar trim.
(7) Install seat belt height adjuster knob.
(8) Refit weatherstrip.
B-PILLAR UPPER TRIM
REMOVAL
(1) Disengage shoulder belt turning loop cover.
(2) Remove adjuster knob.
(3) Remove bolt attaching turning loop to shoulder
belt height adjuster.
(4) Remove turning loop from adjuster.
(5) Disengage clips attaching upper trim to B-pil-
lar (Fig. 4).
(6) Remove B-pillar trim from vehicle.
INSTALLATION
(1) Place B-pillar trim in position on vehicle.
(2) Engage clips attaching upper trim to B-pillar.
(3) Place shoulder belt turning loop in position on
adjuster.
(4) Install adjuster knob.
(5) Install bolt attaching turning loop to shoulder
belt height adjuster.
(6) Install shoulder belt turning loop cover.
(7) Refit weatherstrip.
CROSS CAR BEAM
REMOVAL
(1) Remove steering column and instrument panel
from vehicle.
(2) Remove fasteners attaching cross car beam to
plenum in both locations (Fig. 5).
(3) Remove left side fasteners attaching the cross
car beam to cowl side panel.
(4) Remove right side fasteners attaching the cross
car beam to cowl side panel.
(5) Remove cross car beam from vehicle.
INSTALLATION
(1) Place cross car beam in position in vehicle.
(2) Install right side fasteners attaching the cross
car beam to cowl side panels.
(3) Install left side fasteners attaching the cross
car beam to cowl side panels.
(4) Install fasteners to plenum in both locations.
(5) Install steering column and instrument panel.
LH