Chrysler 300M Service Manual page 1149

19 - 62 PUMP
PUMP (Continued)
(2) Using a siphon pump, remove as much power
steering fluid as possible from the power steering
fluid reservoir.
(3) Raise vehicle. (Refer to LUBRICATION &
MAINTENANCE/HOISTING - STANDARD PROCE-
DURE)
(4) Remove the power steering fluid supply hose
(Fig. 9) from the supply fitting on the power steering
pump.
Fig. 9 Power Steering Fluid Supply Hose At Power
Steering Pump
1 - POWER STEERING FLUID SUPPLY HOSE
2 - POWER STEERING PUMP
(5) Let power steering fluid drain from the power
steering fluid reservoir and power steering pump.
(6) Install a cap on the open nipple of the power
steering fluid reservoir to prevent power steering
fluid from spilling when removing the power steering
pump.
(7) Remove the power steering fluid pressure hose
(Fig. 10) from the pressure fitting on the power steer-
ing pump.
(8) Let remaining power steering fluid drain from
the power steering pump.
(9) Loosen the lock-nut (Fig. 11) on the front of the
pulley for the serpentine drive belt tensioner.
(10) Using the adjustment bolt (Fig. 11) remove
the tension from the drive belt for the power steering
pump.
(11) Remove the drive belt from the power steering
pump pulley.
NOTE: Access for the power steering pump mount-
ing bolts is through the holes in the face of the
power steering pump pulley.
Fig. 10 Pressure Hose At Power Steering Pump
1 - POWER STEERING PUMP
2 - POWER STEERING FLUID PRESSURE HOSE
Fig. 11 Drive Belt Tensioner Lock-Nut And
Adjustment Bolt
1 - ADJUSTMENT BOLT
2 - POWER STEERING PUMP
3 - LOCK-NUT
4 - DRIVE BELT
(12) Remove the 3 bolts attaching the power steer-
ing pump to the power steering pump mounting
bracket.
LH