Side View Mirror Removal; Installation; Side View Mirror Glass Removal - Chrysler 300M Service Manual

LH
SIDE VIEW MIRROR
REMOVAL
(1) Remove side view mirror cover.
(2) Remove the door trim panel.
(3) Disconnect power window mirror motor wire
connector, if so equipped.
(4) Disengage power mirror wire connector.
(5) Remove nuts attaching side view mirror to mir-
ror flag.
(6) Remove side view mirror from vehicle.

INSTALLATION

(1) Position side view mirror to vehicle.
(2) Install nuts attaching side view mirror to mir-
ror flag.
(3) Engage push pin fastener attaching power mir-
ror wire connector to inner door panel, if so equipped.
(4) Engage power mirror motor wire connector, if
so equipped.
(5) Install side view mirror cover.
SIDE VIEW MIRROR GLASS
REMOVAL
WARNING: ALWAYS WEAR EYE AND HAND PRO-
TECTION WHEN SERVICING THE MIRROR ASSEM-
BLY. FAILURE TO OBSERVE THESE WARNINGS
MAY RESULT IN PERSONAL INJURY FROM BRO-
KEN GLASS.
(1) Carefully pull/pry the broken glass holder from
the mirror assembly.
(2) Disconnect the heated mirror electrical connec-
tors from the terminals on the mirror glass holder, if
equipped.
INSTALLATION
CAUTION: It is important to make sure the motor is
square to the glass holder (attaching fingers) prior
to glass holder attachment, otherwise the glass
holder could be installed incorrectly causing poor
retention and possible repeat failure.
(1) Position the new mirror glass holder to the
mirror assembly.
NOTE: Position the mirror glass holder so that the
moisture drain hole on the mirror glass holder
assembly is facing downward.
(2) Align the mirror glass holder's attaching fin-
gers to the mirror motor housing.
NOTE: Ensure that the protective rubber cover of
the mirror motor housing is positioned correctly
around the bottom of the fingers area.
(3) Using one hand, firmly press the mirror glass
holder assembly into place while at the same time
supporting the housing assembly from the backside
with the other hand.
NOTE: Pressure must be applied equally over the
center portion of the mirror to engage the mirror
glass holder's attaching fingers to the correspond-
ing fingers on the housing assembly. One or more
clicks may be heard when finger engagement takes
place.
(4) Verify retention of the mirror glass holder
assembly by gently pulling outward on the mirror
glass holder.
EXTERIOR 23 - 39