Removal - Pump (3.5L Engine) - Chrysler 300M Service Manual

LH
PUMP (Continued)
(7) Let remaining power steering fluid drain from
the power steering pump.
(8) Loosen the lock-nut (Fig. 6) on the front of the
pulley for the serpentine drive belt tensioner.
Fig. 6 Drive Belt Tensioner Lock-Nut And
Adjustment Bolt
1 - PULLEY
2 - ADJUSTMENT BOLT
3 - POWER STEERING FLUID RESERVOIR
4 - DRIVE BELT
5 - LOCK-NUT
(9) Using the adjustment bolt (Fig. 6) remove the
tension from the drive belt for the power steering
pump.
(10) Remove the drive belt from the power steering
pump pulley.
NOTE: Access for the power steering pump mount-
ing bolts is through the holes in the face of the
power steering pump pulley.
(11) Remove the 3 bolts attaching the power steer-
ing pump to the power steering pump mounting
bracket.
NOTE: The following step must be performed to
have the space necessary to remove the power
steering pump from the mounting bracket.
(12) Insert a screwdriver between the power steer-
ing pump and the sleeve in the tensioner bracket
(Fig. 7). Using the screwdriver push the sleeve for-
ward in the tensioner bracket until it is flush with
the back side of the tensioner bracket (Fig. 7).
(13) Remove the power steering pump, power
steering fluid reservoir and pulley as an assembly
from the engine. Power steering pump is removed
from the top of the engine.
(14) Transfer the required parts from the removed
power steering pump to the replacement power steer-
Fig. 7 Tensioner Bracket To Power Steering Pump
1 - SCREWDRIVER
2 - POWER STEERING PUMP
3 - SLEEVE
4 - TENSIONER BRACKET
ing pump. See Disassembly and Assembly in this sec-
tion.

REMOVAL - PUMP (3.5L ENGINE)

(1) Remove the battery ground cable from the
ground stud on the shock tower and isolate the
ground cable by installing the cable isolator on the
ground stud (Fig. 8).
Fig. 8 Correctly Isolated Remote Ground Cable
1 - CABLE ISOLATOR
2 - GROUND STUD
3 - GROUND CABLE
NOTE: The following step should be done to pre-
vent excessive spilling of power steering fluid when
the power steering fluid lines are removed from the
power steering pump.
PUMP 19 - 61
Sleeve