Chrysler 300M Service Manual page 1244

LH
FINAL DRIVE (Continued)
(3) Install new front bearing (actual bearing to be
used during reassembly) onto gauge disc (special tool
6549-3) (Fig. 190).
Fig. 190 Gauge Disc and Bearing
1 - FRONT TRANSFER SHAFT BEARING
2 - SPECIAL TOOL 6549–3
(4) Install gauge disc and bearing into case using
gauge disc rod Tool 6549-4 (Fig. 191).
Fig. 191 Installing Gauge Disc with
1 - FRONT TRANSFER SHAFT BEARING
2 - SPECIAL TOOL 6549–3
(5) Install centering disc (special tool 6494-2) onto
gauge disc rod (Fig. 192).
(6) Install centering nut Tool 6549-5 as shown in
(Fig. 193).
(7) Hand tighten centering nut until all play in the
tool has been removed.
(8) Install dial indicator into locating block Tool
6549-1. Then screw extension rod onto dial indicator
(Fig. 194).
Fig. 192 Disc Installation
1 - SPECIAL TOOL 6494–2
Fig. 193 Installing Centering Nut
1 - CENTERING NUT
2 - CENTERING DISC (6494–2)
Fig. 194 Dial indicator, Locating Block and
Extension Rod
1 - EXTENSION ROD SPECIAL TOOL
2 - LOCATING BLOCK SPECIAL TOOL
3 - DIAL INDICATOR
TRANSAXLE 21 - 83