Installation; Rear Wiper Motor Trim Cover Removal - Chrysler Vehicle User Manual

TJ
REAR WIPER MOTOR (Continued)
Fig. 19 Rear Wiper Motor Output Shaft
1 - WASHER
2 - NUT
3 - GROMMET
4 - STUD
5 - LIFTGLASS
6 - REAR WASHER NOZZLE
7 - REAR WIPER MOTOR OUTPUT SHAFT
(7) Remove the nut and washer that secures the
rear wiper motor bracket insulator to the stud on the
liftglass (Fig. 20).
Fig. 20 Rear Wiper Motor Bracket
1 - BRACKET
2 - INSULATOR
3 - RIGHT LIFTGLASS HINGE
4 - LIFTGLASS
5 - WASHER
6 - STUD
7 - NUT
(8) Remove the washer from the stud that secures
the rear wiper motor bracket insulator to the lift-
glass.
(9) From the inside of the liftglass, gently pull the
rear wiper motor away from the liftglass until the
REAR WIPERS/WASHERS
output shaft clears the rubber grommet in the lift-
glass output shaft hole.
(10) Remove the rear wiper motor and mounting
bracket from the liftglass as a unit.
(11) Remove the rubber grommet from the outside
of the liftglass output shaft hole.

INSTALLATION

(1) Install the rubber grommet from the outside of
the liftglass output shaft hole. Be certain that the
alignment arrow molded into the outer flange of the
grommet is aligned with the arrowhead imprinted on
the glass below the output shaft hole.
(2) Position the rear wiper motor to the inside of
the liftglass with the output shaft inserted through
the rubber grommet and the mounting bracket insu-
lator installed over the stud on the inside of the lift-
glass (Fig. 20).
(3) Reinstall the washer onto the stud that secures
the rear wiper motor bracket insulator to the lift-
glass.
(4) Install and tighten the nut and washer that
secures the rear wiper motor bracket insulator to the
stud on the liftglass. Tighten the nut to 6 N·m (54 in.
lbs.).
(5) From the outside of the liftglass, reinstall the
washer over the rear wiper motor output shaft sleeve
(Fig. 19).
(6) Install and tighten the nut that secures the
threaded sleeve of the rear wiper motor output shaft
to the outside of the liftglass. Tighten the nut to 5
N·m (44 in. lbs.).
(7) Reconnect the hardtop wire harness connector
for the rear wiper motor to the motor pigtail wire
connector.
(8) Reinstall the trim cover over the rear wiper
motor on the inside of the liftglass. (Refer to 8 -
ELECTRICAL/REAR
WIPER MOTOR TRIM COVER - INSTALLATION).
(9) Reinstall the rear wiper arm onto the rear
wiper motor output shaft. (Refer to 8 - ELECTRI-
CAL/REAR WIPERS/WASHERS/REAR WIPER ARM
- INSTALLATION).
(10) Reconnect the battery negative cable.
REAR WIPER MOTOR TRIM
COVER
REMOVAL
(1) From the inside of the liftglass, remove the
three screws that secure the rear wiper motor trim
cover to the motor mounting bracket (Fig. 21).
(2) Remove the trim cover from the rear wiper
motor mounting bracket.
8R - 39
WIPERS/WASHERS/REAR