Chrysler 300M Service Manual page 1206

LH
42LE AUTOMATIC TRANSAXLE (Continued)
Fig. 143 Install Overdrive Accumulator and Springs
1 - OVERDRIVE ACCUMULATOR PISTON
2 - RETURN SPRINGS
3 - SEAL RING
4 - SEAL RING
CAUTION: Do not handle the valve body by the
manual shaft. Damage could result.
(51) Install valve body into place as shown in (Fig.
144).
Fig. 144 Install Valve Body To Transaxle
1 - VALVE BODY
(52) Install seven (7) valve body-to-case bolts (Fig.
145) and torque to 12 N·m (105 in. lbs.).
Fig. 145 Install Valve Body Bolts (7)
1 - EXTENSION
2 - SOCKET
3 - VALVE BODY
(53) Install transaxle oil filter (Fig. 146).
Fig. 146 Install Transaxle Oil Filter
1 - TRANSAXLE FILTER
2 - FILTER RETAINING CLIPS
(54) Install transaxle oil pan (Fig. 147) with a
bead of Mopar ATF RTV (MS-GF41). Torque oil pan-
to-case bolts to 23 N·m (17 ft. lbs.).
Install both speed sensors from transaxle case (Fig.
148). Torque speed sensors to 27 N·m (20 ft. lbs.).
(55) As a final check of the transaxle, measure the
input shaft end play. This will indicate when a #4
thrust plate change is required. The number 4 thrust
plate is located behind the overdrive clutch hub.
Attach a dial indicator to transaxle bell housing with
its plunger seated against end of input shaft (Fig.
149). Move input shaft in and out to obtain end play
TRANSAXLE 21 - 45