Chrysler 300M Service Manual page 1063

LH
FUEL TANK (Continued)
Fig. 18 Fuel and EVAP Lines
1 - EVAP LINES
2 - BRAKE LINES
3 - FUEL LINE
(12) Remove the wiring harness from the heat
shield, if needed (Fig. 19).
Fig. 19 HARNESS TAB ON HEAT SHIELD
1 - Wiring Harness
2 - Heat Shield
(13) Lower tank more and remove the wiring har-
ness from fuel tank pin, if needed (Fig. 20).
(14) Remove wiring harness from body.
(15) Remove NVLD filter from mounting location.
(16) Remove fuel tank (Fig. 21).
INSTALLATION
(1) Raise the fuel tank on the transmission stand
(Fig. 21).
(2) Install fuel pump electrical connector into hole
in the body.
Fig. 20 HARNESS ON TANK PIN
1 - Pin
2 - Wiring Harness
Fig. 21 FUEL TANK
(3) Connect wiring harness to fuel tank pin, if
removed (Fig. 20).
(4) Connect wiring harness to heat shield, if
removed (Fig. 19).
(5) Connect the purge and vent lines (Fig. 18).
(6) Raise tank into position and install tank
straps.
(7) Install the fuel filler tube and tighten the
clamp (Fig. 15).
(8) Reposition the stabilizer bar and install bolts.
(9) Lower vehicle.
(10) Connect the fuel pump electrical connector
that is under the rear seat (Fig. 14).
(11) Install the rear seat, refer to the Body section
for more information.
(12) Connect the battery cable (Fig. 13).
(13) Fill fuel tank. Use the DRB scan tool to pres-
surize the fuel system. Check for leaks.
FUEL DELIVERY 14 - 11