Installation; Timing Belt Cover(S) - Rear Removal - Chrysler 300M Service Manual

9 - 80 ENGINE
TIMING BELT COVER(S) - FRONT (Continued)
(6) Remove the lower belt cover located behind the
crankshaft vibration damper (Fig. 135).
(7) Remove the A/C belt guide/lift bracket (Fig.
134).
Fig. 134 A/C BELT GUIDE/LIFT BRACKET
1 - A/C BELT GUIDE/LIFT BRACKET
2 - NUT
(8) Remove the stamped steel cover (Fig. 135). Do
not remove the sealer on the cover, it is reus-
able (Fig. 136). If some sealer is missing use
Mopar Engine RTV GEN II to replace the missing
sealer.
(9) Remove the left cast cover (Fig. 135).
Fig. 135 TIMING BELT COVERS
1 - RIGHT SIDE COVER (STAMPED)
2 - LEFT SIDE COVER (CAST)
3 - LOWER COVER

INSTALLATION

(1) Install the left cast cover (Fig. 135) and gener-
ator/power steering belt tensioner pulley and bracket.
Fig. 136 TIMING BELT COVER SEALER
1 - SEALER
(2) Install the right stamped steel cover (Fig. 135).
(3) Install A/C belt guide/lift bracket (Fig. 134).
(4) Install the lower cover (Fig. 135).
(5) Install the crankshaft vibration damper. (Refer
to 9 - ENGINE/ENGINE
DAMPER - INSTALLATION)
(6) Install the accessory drive belts. (Refer to 7 -
COOLING/ACCESSORY DRIVE/DRIVE BELTS -
INSTALLATION)
(7) Install the radiator fan. (Refer to 7 - COOL-
ING/ENGINE/RADIATOR FAN - INSTALLATION)
(8) Install upper radiator crossmember. (Refer to
23 - BODY/EXTERIOR/GRILLE OPENING REIN-
FORCEMENT - INSTALLATION)
(9) Connect negative cable to remote jumper termi-
nal.
TIMING BELT COVER(S) -
REAR
REMOVAL
(1) Remove camshaft sprocket(s). (Refer to 9 -
ENGINE/VALVE TIMING/TIMING
AND SPROCKETS - REMOVAL)
(2) Remove rear timing belt cover bolts (Fig. 137).
(3) Remove the rear cover(s).
NOTE: The right side rear timing belt cover has
O-rings to seal the water pump passages to cylin-
der block (Fig. 139). Do not reuse the O-rings.
INSTALLATION
(1) Inspect the rear cover foam seals for damage or
wear (Fig. 138). Replace as neccessary.
LH
BLOCK/VIBRATION
BELT/CHAIN