Specifications - Torque; Engine Cradle Crossmember; Removal; Installation - Chrysler 300M Service Manual

LH
FRAME (Continued)

SPECIFICATIONS - TORQUE

TORQUE SPECIFICATIONS
DESCRIPTION
Rear bumber reinforcement
attaching nut
Front suspension crossmember
front attaching bolt
Front suspension crossmember
rear attaching bolt
Radiator support crossmember
attaching bolts
ENGINE CRADLE
CROSSMEMBER

REMOVAL

CAUTION: VERIFY THAT VEHICLE IS PROPERLY
SUPPORTED AND SECURED TO THE LIFTING
DEVICE. VEHICLE CENTER OF GRAVITY WILL
CHANGE WHEN HEAVY
REMOVED CAUSING A HAZARDOUS CONDITION.
(1) Release hood latch and open hood.
(2) Remove nuts holding engine mounts to cradle.
(3) Install a suitable engine support device.
(4) Raise and support vehicle on safety stands.
(5) Remove bolts holding transaxle crossmember to
cradle.
(6) Lower vehicle and lift engine and transaxle off
cradle.
(7) Raise and support vehicle on safety stands.
(8) Disconnect sway bar links.
(9) Remove bolts retaining suspension lower ball
joints to spindles.
(10) Separate lower control arm from spindle.
Refer to Group 2, Suspension, for proper procedures.
(11) Support cradle on a 10 cm by 10 cm by 90 cm
(4 in. by 4 in. by 36 in.) wood beam and a jack.
(12) Remove bolts holding cradle to body shell
(Fig. 15).
(13) Lower cradle away from body shell.

INSTALLATION

NOTE: If cradle replacement is required, transfer
suspension components and jounce and bounce
plates to replacement cradle.
(1) Support cradle on wood beam and a jack.
(2) Position cradle under body shell.
Ft. In.
N·m
Lbs. Lbs.
28 21 —
109 80 —
102 75 —
51 45 —
COMPONENTS ARE
Fig. 15 ENGINE CRADLE
1 - FRONT FRAME RAILS
2 - TRANSAXLE CROSSMEMBER
3 - CROSSMEMBER BOLTS
4 - CROSSMEMBER BOLTS
5 - CRADLE MOUNT BOLTS
6 - ENGINE CRADLE
7 - ENGINE MOUNT BOLTS
(3) Install bolts to hold cradle to body shell.
(4) Connect lower control arms to spindles. Refer
to Group 2, Suspension, for proper procedures.
(5) Install bolts to retain suspension lower ball
joints to spindles.
(6) Connect sway bar links.
(7) Lower vehicle and lower engine and transaxle
onto cradle.
(8) Raise vehicle.
(9) Install bolts to hold transaxle crossmember to
cradle.
(10) Lower vehicle.
(11) Remove engine support device.
(12) Install nuts to hold engine mounts to cradle.
(13) Align front suspension if necessary.

FRONT TOW EYE

REMOVAL
(1) Unthread the front tow eye from the tow eye
bracket (Fig. 16).
(2) Remove the front tow eye.
FRAME & BUMPERS 13 - 9