Installation; Rear View Mirror Removal; Installation - Rearview Mirror Support Bracket - Chrysler 300M Service Manual

23 - 72 INTERIOR
REAR SHELF TRIM PANEL (Continued)
Fig. 22 PARCEL SHELF TRIM PANEL
1 - REAR SHELF TRIM
2 - PUSH PIN FASTENER
3 - CLIP LOCATION

INSTALLATION

(1) Place rear shelf trim panel in position in vehi-
cle.
(2) Feed center seat belt and bezel through rear
trim panel.
(3) Connect CHMSL wire connector.
(4) Push parcel shelf trim rearward toward rear
glass and engage clips.
(5) Insert push pin fasteners into position.
(6) Install quarter trim lower and upper panels.
(7) Install center seat belt anchor bolt. Tighten to
40 N·m (29 ft. lbs.) torque.
(8) Install seat back and cushion.
REAR VIEW MIRROR
REMOVAL
(1) If equipped, disconnect mirror harness connec-
tor.
(2) Loosen the mirror base setscrew (Fig. 23).
(3) Slide the mirror base upward and off the
bracket.
INSTALLATION
INSTALLATION
(1) Position the mirror base at the bracket and
slide it downward onto the support bracket (Fig. 23).
(2) Tighten the setscrew 1 N·m (15 in. lbs.) torque.
(3) If equipped, connect mirror harness connector.
Fig. 23 REAR VIEW MIRROR
1 - CONNECTOR
2 - SCREW
3 - REAR VIEW MIRROR
4 - SUPPORT BUTTON
5 - WINDSHIELD
INSTALLATION - REARVIEW MIRROR
SUPPORT BRACKET
(1) Mark the position for the mirror bracket on the
outside of the windshield glass with a wax pencil.
(2) Clean the bracket contact area on the glass.
Use a mild powdered cleanser on a cloth saturated
with isopropyl (rubbing) alcohol. Finally, clean the
glass with a paper towel dampened with alcohol.
(3) Sand the surface on the support bracket with
fine grit-sandpaper. Wipe the bracket surface clean
with a paper towel.
(4) Apply accelerator to the surface on the bracket
according to the following instructions:
(a) Crush the vial to saturate the felt applicator.
(b) Remove the paper sleeve.
(c) Apply accelerator to the contact surface on
the bracket.
(d) Allow the accelerator to dry for five minutes.
(e) Do not touch the bracket contact surface
after the accelerator has been applied.
(5) Apply adhesive accelerator to the bracket con-
tact surface on the windshield glass. Allow the accel-
erator to dry for one minute. Do not touch the glass
contact surface after the accelerator has been
applied.
(6) Install the bracket according to the following
instructions:
(a) Apply one drop of adhesive at the center of
the bracket contact-surface on the windshield
glass.
(b) Apply an even coat of adhesive to the contact
surface on the bracket.
(c) Align the bracket with the marked position
on the windshield glass.
LH