Center Console Armrest Lid Assembly Removal; Installation; Center Console Bezel Removal - Chrysler 300M Service Manual

23 - 64 INTERIOR
CENTER CONSOLE ARMREST
LID ASSEMBLY
REMOVAL
(1) Open armrest lid.
(2) Remove lid attaching screws.
(3) Remove lid from console.

INSTALLATION

(1) Place lid in position.
(2) Install screws attaching lid to console.
(3) Check operation of lid.
CENTER CONSOLE BEZEL
REMOVAL
NOTE: The Transmission Range Indicator Lamp
(electroluminescent) is not serviceable. Replace
Floor Console Panel for replacement of the lamp.
(1) Set park brake and place gear selector in neu-
tral.
(2) Remove instrument panel center bezel. (Refer
to 23 - BODY/INSTRUMENT PANEL/INSTRUMENT
PANEL CENTER BEZEL - REMOVAL)
1 - INSTRUMENT PANEL
2 - FLOOR CONSOLE SHIFT BEZEL
3 - TRANSMISSION RANGE INDICATOR ILLUMINATION
CONNECTORS
Fig. 7 FLOOR CONSOLE BEZEL - CONCORDE
(3) Loosen set screw attaching gear shift knob to
gear shift.
(4) Remove gear shift knob from gear shift.
(5) Disengage clips attaching bezel to floor console
(Fig. 7), or (Fig. 8).
(6) Disconnect the power outlet, if equipped.
(7) Disconnect the transmission range indicator
illumination connector.
(8) Remove bezel from vehicle.
INSTALLATION
(1) Connect the transmission range indicator illu-
mination connector.
(2) Connect power outlet, if equipped.
(3) Place bezel in position on vehicle.
(4) Engage clips attaching bezel to floor console.
(5) Install instrument panel center bezel. (Refer to
23 - BODY/INSTRUMENT PANEL/INSTRUMENT
PANEL CENTER BEZEL - INSTALLATION)
(6) Push gear shift knob onto gear shift.
(7) Tighten set screw attaching gear shift knob to
gear shift.
4 - REAR BEZEL
5 - FLOOR CONSOLE
LH