Installation; Front Fender Removal - Chrysler 300M Service Manual

LH
GRILLE OPENING REINFORCEMENT (Continued)
Fig. 4 UPPER RADIATOR CLOSURE
1 - ATTACHING BOLTS
2 - JACKSCREW
3 - FASTENERS

INSTALLATION

(1) Place in position the upper radiator closure
panel.
(2) Connect hood latch cable to hood latch.
(3) Install bolts attaching upper radiator closure
panel. Check bolt alignment marks.
(4) Install bolts attaching the forward edge of
upper radiator closure panel.
(5) Install fasteners attaching upper bumper fas-
cia.
(6) Install headlamp jackscrews both sides.
(7) Check hood latch operation.
FRONT FENDER
REMOVAL
(1) Remove headlamp housing.
(2) Remove splash shield to fascia plastic rivets.
(3) Remove splash shield to sill cladding.
(4) First remove fender bolt to lower cowl.
(5) Next drill a 30 mm (1 1/16 in.) hole in the
splash shield to access the upper cowl bolt. Remove
bolt.
(6) Then loosen fender bolt to upper cowl.
(7) Pull fascia away from fender.
(8) Remove bolts to lower radiator closure panel.
(9) Support the hood and disconnect hood prop rod.
(10) From inside engine compartment, remove
bolts attaching fender to upper rail.
(11) Remove fender from vehicle (Fig. 5).
Fig. 5 FENDER
1 - FRONT FENDER
2 - TO UPPER RAIL
3 - TO RADIATOR CLOSURE PANEL
4 - TO LOWER COWL
5 - TO UPPER COWL
INSTALLATION
(1) Place fender in position on vehicle.
(2) From inside engine compartment, install bolts
to attach fender to upper rail.
(3) Connect hood prop rod and support the hood
(4) Install fender bolts to lower radiator closure
panel.
(5) Place fascia into position.
(6) Tighten fender bolt to the upper cowl. Use plug
that come with fender to fill drilled hole in splash
shield.
(7) Install fender bolt to lower cowl.
(8) Install splash shield plastic rivets to sill clad-
ding.
(9) Install splash shield plastic rivets to fascia.
(10) Install headlamp assembly.
(11) Check fender for flush and gap.
EXTERIOR 23 - 37