Rear Fascia - Intrepid; Removal - Intrepid; Installation - Intrepid; Frame - Chrysler 300M Service Manual

13 - 4 FRAME & BUMPERS
REAR FASCIA (Continued)
(2) Partially remove trunk carpet to gain access to
fascia attaching nuts and remove nuts.
(3) 300M only, remove both tail lamp housings to
gain access to fascia attaching fasteners and remove
attaching fasteners.
(4) Remove fasteners attaching fascia to rear quar-
ter and splash shield.
(5) Remove upper push pins attaching the fascia to
the body.
(6) Pull fascia with 30 pound force to disengage
plastic clip and grommet that attaches the fascia to
the quarter panel vertical flange one side at a time
(Fig. 9).
(7) Disengage main wire connector from the body
harness. The connector is on the left side of vehicle.
(8) Remove fascia from vehicle.
Fig. 9 REAR BUMPER FASCIA
INSTALLATION
(1) Connect main wire connector to the body har-
ness connector.
(2) Place rear fascia in position on bumper rein-
forcement.
(3) Align the two fascia studs to the quarter panel
vertical attachment, at the same time align the fas-
cia key hole slot on the horizontal flange with the
drive pin. Push fascia forward to engage the fasten-
ers.
(4) Install push pins attaching top of fascia to
body.
(5) 300M only, install nut on fascia stud and
install tail lamp and fasteners under tail lamp.
(6) Install trunk carpet back in position.
(7) Install fasteners attaching fascia to rear quar-
ter panel and splash shields.

REAR FASCIA - INTREPID

REMOVAL - INTREPID

(1) Open deck lid.
(2) Remove fasteners attaching fascia to rear quar-
ter and splash shields.
(3) Remove fasteners attaching fascia to lower
trunk panel.
(4) Pull sides of fascia outwards to disengage
snaps to quarter panel attaching bracket (Fig. 10).
(5) Pull fascia rearward to expose license plate
lamp wire connector. Disconnect wire harness connec-
tor. The connector is located on the left side of vehi-
cle.
Fig. 10 REAR BUMPER FASCIA
1 - LOWER TRUNK OPENING
2 - REAR FASCIA

INSTALLATION - INTREPID

(1) Connect the license plate lamp wire connector
to the body harness.
(2) Place rear fascia in position on vehicle, by fit-
ting foam to bumper beam.
(3) Install center fastener to lower trunk panel.
(4) Snap sides of fascia between quarter panel and
bracket.
(5) Install fasteners attaching fascia to rear quar-
ter panel and splash shields.
(6) Install the remaining fasteners to lower trunk
panel.

FRAME

SPECIFICATIONS

FRAME DIMENSIONS

Frame dimensions are listed in metric scale then
converted to inch scale listed in parenthesis. All
dimensions are from center to center of Principal
Locating Point (PLP), or from center to center of PLP
and fastener location. Vertical dimensions can be taken
from the work surface to the locations indicated.
LH