Window Regulator Removal; Installation; Cable - Remote Lock Actuator Removal - Chrysler 300M Service Manual

LH
WINDOW REGULATOR
REMOVAL
(1) Remove flag cover, door trim panel, water
shield as necessary, and pull cup support bracket.
(Refer to 23 - BODY/DOORS - REAR/TRIM PANEL -
REMOVAL)
(2) Slide glass from regulator roller channel (Fig.
12).
(3) Disconnect power window motor wire connec-
tor.
(4) Loosen screw attaching regulator scissor chan-
nel to door panel.
(5) Remove screw and bolt heads from keyhole
slots in door panel.
(6) Loosen bolt attaching regulator support brace
to door panel.
(7) Loosen bolts attaching regulator to door panel.
(8) Remove regulator from door panel.
(9) Slide regulator rearward and rotate forward
end of roller channel through access hole in door
panel.
Fig. 12 REAR DOOR WINDOW REGULATOR
1 - GLASS
2 - LIFT PLATES
3 - GLASS ROLLER CHANNEL
4 - WINDOW REGULATOR
5 - REAR DOOR

INSTALLATION

(1) Insert roller channel through access hole in
door panel.
(2) Insert bolt and screw heads through key hole
slots in door panel.
(3) Tighten bolts attaching regulator to door panel.
(4) Tighten bolt to attach regulator support brace
to door panel.
(5) Tighten screw to attach regulator scissor chan-
nel to door panel.
(6) Connect power window motor wire connector.
(7) Lower door glass on to regulator roller channel.
(8) Align glass and verify operation.
(9) Install pull cup support bracket, water shield,
door trim panel and flag cover.
CABLE - REMOTE LOCK
ACTUATOR
REMOVAL
(1) Open the front door.
(2) Loosen the actuator knob lock nut.
(3) Remove the lock actuator knob and lock nut.
(4) Remove the cable housing nut.
(5) Remove the trim panel and watershield. (Refer
to 23 - BODY/DOORS - REAR/TRIM PANEL -
REMOVAL)
(6) Remove the support bracket screws.
(7) Release the clip at the latch and disconnect the
cable.
(8) Remove support tie straps, if equipped.
INSTALLATION
(1) Install the cable into the door and through the
hole in the door shut face.
(2) Install and tighten the cable nut.
(3) Install the knob lock nut and the actuator
knob.
(4) Tighten the lock nut.
(5) Attach the cable to the latch and engage the
clip.
(6) Install the support bracket screws and verify
correct actuator operation.
(7) Loosen the support bracket screws and adjust
the cable if necessary.
(8) Replace any support tie straps, if equipped.
(9) Install the watershield and the trim panel.
(Refer to 23 - BODY/DOORS - REAR/TRIM PANEL -
INSTALLATION)
DOORS - REAR 23 - 33