Rear Mount Removal; Installation; Right Mount Removal - Chrysler 300M Service Manual

LH
REAR MOUNT
REMOVAL
(1) Raise vehicle on hoist.
(2) Support transaxle with a jack.
(3) Remove isolator nuts from the mount to trans-
axle mount bracket (Fig. 99).
(4) Remove rear mount isolator bolts to crossmem-
ber and remove mount (Fig. 99).

INSTALLATION

(1) Position isolator onto crossmember.
(2) Install bolts attaching isolator to crossmember
and tighten to 33 N·m (250 in. lbs.) (Fig. 99).
(3) Lower transaxle onto isolator.
(4) Install isolator nuts and tighten to 61 N·m (45
ft. lbs.) (Fig. 99).
(5) Lower vehicle.
1 - NUT
2 - REAR ISOLATOR
3 - BOLT
4 - NUT
5 - ISOLATOR
RIGHT MOUNT
REMOVAL
(1) Raise vehicle on hoist.
(2) Remove the isolator attaching nuts from top of
the mounting bracket (Fig. 99).
(3) Support the engine with a jack and a block of
wood across the full width of the oil pan.
(4) Remove the lower attaching nuts from the bot-
tom of the isolator to the frame (Fig. 99).
(5) Raise engine carefully with jack enough to
remove the isolator with heat shield from its mount.
INSTALLATION
(1) Install isolator mount with heat shield onto the
frame.
(2) Lower the engine onto the isolator mount.
(3) Remove jack from vehicle.
(4) Tighten the isolator to frame nuts to 61 N·m
(45 ft. lbs.) (Fig. 99).
(5) Install the upper attaching nuts to mount and
tighten to 61 N·m (45 ft. lbs.) (Fig. 99).
(6) Lower vehicle.
Fig. 99 ENGINE MOUNTING
6 - HEAT SHIELD
7 - BOLT
8 - ENGINE MOUNT BRACKET
9 - NUT
ENGINE 9 - 59