Removal; Front Fascia; Removal - Intrepid - Chrysler 300M Service Manual

13 - 2 FRAME & BUMPERS

FRONT FASCIA

REMOVAL

REMOVAL
(1) Release hood latch and open hood.
(2) Remove large rubber grommet (70 mm x 168
mm) from splash shield to gain access to fascia fas-
teners (Fig. 2).
(3) Remove fasteners attaching fascia to the front
fender and splash shield.
(4) Remove the nuts on the fascia studs through
the splash shield access holes on each side (Fig. 3).
(5) Remove the fasteners attaching the fascia to
the lower crossmember (Fig. 4).
(6) Remove the fasteners attaching the fascia to
the upper radiator closure panel (Fig. 4).
(7) Disconnect wire connectors (fog lamps, parking/
turn signal, side marker), if equipped (Fig. 5).
(8) Remove fascia from vehicle.
Fig. 2 ACCESS RUBBER GROMMET
1 - ACCESS RUBBER GROMMET

REMOVAL - INTREPID

(1) Release hood latch and open hood.
(2) Remove push pin fasteners attaching bottom of
fascia (air dam) to lower crossmember (Fig. 6).
(3) Remove fasteners attaching fascia to splash
shields (Fig. 7).
(4) Remove push pin fasteners attaching the fascia
to upper radiator closure panel.
(5) Pull the sides of the fascia outwards to disen-
gage fascia from drive pins then pull fascia forward.
(6) Disconnect fog
equipped.
(7) Remove fascia from vehicle.
lamp wire connectors,
Fig. 3 FASTENER LOCATIONS
1 - THROUGH ACCESS REMOVE FASTENER
2 - FASTENERS
Fig. 4 REMOVE PUSH PIN FASTENERS
1 - PUSH PIN FASTENERS
Fig. 5 FRONT BUMPER FASCIA
1 - BODY & FASCIA WIRE CONNECTORS
if
2 - FRONT FASCIA
LH