Chrysler 300M Service Manual page 1109

19 - 22 COLUMN
COLUMN (Continued)
(b) Slide the solenoid completely onto the shift
lever mounting stud aligning the plastic guide
formed into the solenoid housing with the flange on
the shift lever mechanism bracket (Fig. 30).
(c) Install the retainer clip until it snaps into
place in the slot cut into the shift lever mounting
stud (Fig. 31).
(d) Verify the solenoid is locked in place and will
not slide off the mounting stud.
(e) Connect the wiring harness connector to the
solenoid.
Fig. 30 Guide And Flange Alignment
1 - BRACKET FLANGE
2 - GUIDE
Fig. 31 Solenoid Retainer Clip Installation
1 - SOLENOID
2 - MOUNTING STUD
3 - RETAINER CLIP
(9) Install the ignition switch on the steering col-
umn. Install and securely tighten the 2 screws (Fig.
19) mounting the ignition switch to the steering col-
umn.
(10) If the vehicle is equipped with a steering col-
umn mounted shift lever and if a new ignition shift
interlock cassette has been installed, the interlock
system must be adjusted. Adjust the interlock system
by pushing in on the adjustment tab until it stops
(Fig. 32). The adjustment tab will click as it moves
into position. Ensure the tab is fully depressed.
Fig. 32 Ignition Interlock Adjustment Tab
1 - LOCK CYLINDER HOUSING
2 - INTERLOCK CASSETTE
3 - ADJUSTMENT TAB
(11) Install the multi-function switch on the steer-
ing column. Install and securely tighten the two
screws (Fig. 18) mounting the multi-function switch
to the steering column. Install the clockspring wiring
harness on the routing clip on the top of the multi-
function switch.
(12) If the vehicle is equipped, clip the SKIM mod-
ule over the key cylinder halo bezel and attach it to
the steering column with its mounting screw. Con-
nect the wiring harness to the module.
(13) Install the clockspring on the steering column.
Install and securely tighten the two screws (Fig. 17)
mounting the clockspring to the steering column.
(14) Install the wiring harness connectors (Fig. 16)
on the clockspring.
(15) If removed, install the trim ring for the key
cylinder on the lock cylinder housing.
(16) Install the lower shroud (Fig. 15) on the steer-
ing column. Install and securely tighten the 2 screws
attaching the lower shroud to the steering column.
(17) Install the tilt lever (Fig. 14) on the steering
column.
(18) Install the upper shroud on the steering col-
umn by snapping it onto the lower shroud.
LH