Adjustment - Interlock Cable - Chrysler 300M Service Manual

21 - 132 TRANSAXLE
SHIFT INTERLOCK CABLE (Continued)
ADJUSTMENTS

ADJUSTMENT - INTERLOCK CABLE

(1) Remove the shifter handle.
(2) Remove the console bezel.
(3) Move the gear shifter to PARK and the ignition
key to the LOCK position (Fig. 356).
(4) If the interlock cable is being replaced, remove
the pin to allow cable to "self adjust." Press locking
clip (Fig. 357)by hand to secure adjustment.
(5) If the interlock cable is not being replaced, the
pin will not exist. Loosen the locking clip (Fig. 357) on
the interlock cable to allow cable to "self adjust." Press
locking clip (Fig. 357) by hand to secure adjustment.
Fig. 356 Ignition Key/Switch Positions
1 - ACC
2 - LOCK
3 - OFF
4 - ON/RUN
5 - START
Fig. 357 Interlock Cable Removal/Installation
1 - LOCKING CLIP
2 - INTERLOCK CABLE
3 - BRACKET
4 - SHIFTER ASSEMBLY
ACTION
1. Turn key to the OFF
position.
2. Turn key to the
ON/RUN position.
3. Turn key to the
ON/RUN position and
depress the brake pedal.
4. Leave shifter in any
gear and try to return key
to the LOCK or ACC
position.
5. Return shifter to
PARK and try to remove
the key.
6. With the key removed,
try to shift out of PARK .
NOTE: Any failure to meet these expected
responses requires system adjustment or repair.
(6) Install the bezel on the shifter console.
(7) Install shifter handle.
LH
EXPECTED RESPONSE
1. Shifter CAN be shifted
out of park.
2. Shifter CANNOT be
shifted out of park.
3. Shifter CAN be shifted
out of park.
4. Key cannot be
returned to the LOCK or
ACC position.
5. Key can be removed
(after returning to LOCK
position).
6. Shifter cannot be
shifted out of PARK .