Assembly - Chrysler 300M Service Manual

21 - 160 TRANSAXLE
VALVE BODY (Continued)
(17) Remove valves and springs as shown in (Fig.
431).
(18) Cleanliness through entire disassembly and
assembly of the valve body cannot be overempha-
sized. When disassembling, each part should be
washed in a suitable solvent, then dried by com-
pressed air. Do not wipe parts with shop towels.
All mating surfaces in the valve body are accurately
machined; therefore, careful handling of all parts
must be exercised to avoid nicks or burrs.

ASSEMBLY

NOTE: If the valve body assembly is being recondi-
tioned or replaced, it is necessary to perform the
Quick Learn Procedure using the DRBIII
Tool. (Refer to 8 - ELECTRICAL/ELECTRONIC CON-
TROL MODULES/POWERTRAIN CONTROL MODULE
- STANDARD PROCEDURE)
1 - VALVE BODY
2 - T/C REGULATOR VALVE
3 - L/R SWITCH VALVE
4 - CONVERTER CLUTCH CONTROL VALVE
(1) Install valves and springs as shown in (Fig.
432).
(2) Install regulator valve spring retainer (Fig.
433).
(3) Install dual retainer plate using Tool 6301 (Fig.
434).
Scan
Fig. 431 Valve Body Assembly
5 - MANUAL VALVE
6 - CONVERTER CLUTCH SWITCH VALVE
7 - SOLENOID SWITCH VALVE
8 - REGULATOR VALVE
LH