Chrysler 300M Service Manual page 1191

21 - 30 TRANSAXLE
42LE AUTOMATIC TRANSAXLE (Continued)
(7) Install guide bracket pivot shaft (Fig. 85).
Fig. 85 Install Guide Bracket Pivot Shaft
1 - PIVOT PIN
2 - GUIDE BRACKET ASSEMBLY
CAUTION: When installing, be sure guide bracket
and split sleeve touch the rear of the transaxle
case.
(8) Install park sprag pivot retaining screw (Fig.
86) and torque to 5 N·m (45 in. lbs.).
Fig. 86 Install Parking Sprag Pivot Retaining Screw
1 - TRANSFER SHAFT
2 - PARKING SPRAG PIVOT RETAINING SCREW
(9) Install low/reverse piston belleville spring into
position (Fig. 87).
(10) Install and load low/reverse spring compressor
tool as shown in (Fig. 88) (Fig. 89) to facilitate snap
ring installation.
Fig. 87 Install Low/Reverse Piston Return Spring
1 - LOW/REVERSE PISTON RETURN SPRING
2 - PISTON
Fig. 88 Low/Reverse Spring Compressor Tool
1 - TOOL 6057
2 - TOOL 5059
3 - TOOL 5058–3
Fig. 89 Compressor Tool Installed
1 - LOW/REVERSE CLUTCH RETURN SPRING
2 - SNAP RING (INSTALL AS SHOWN)
3 - TOOL 5058A-3
4 - TOOL 5059A
5 - SPECIAL TOOL 6057
LH