Door Glass Removal; Installation; Adjustments Adjustment - Chrysler 300M Service Manual

LH
DOOR GLASS
REMOVAL
(1) Remove flag cover, door trim panel, water
shield as necessary, and pull cup support bracket.(Re-
fer to 23 - BODY/DOOR - FRONT/TRIM PANEL -
REMOVAL)
(2) Connect power window switch and lower win-
dow 150 mm (6 in.) from full up position.
(3) Loosen nuts attaching regulator roller channel
to glass and lift plates.
(4) Slide roller channel rearward to allow lift plate
nuts to pass through key hole slots in channel (Fig.
3).
(5) Remove glass from roller channel.
(6) Raise glass upward and out of the opening at
top of door.
Fig. 3 FRONT DOOR GLASS
1 - FRONT DOOR
2 - LIFT PLATE NUTS
3 - GLASS ROLLER CHANNEL

INSTALLATION

(1) Lower glass into opening at top of door.
(2) Place glass in position against roller channel.
(3) Insert lift plate nuts into key hole slots in
roller channel and slide channel forward to locked
position.
(4) Tighten nuts to attach regulator roller channel
to glass and lift plates.
(5) Install pull cup support bracket, water shield ,
door trim panel, and flag cover. (Refer to 23 - BODY/
DOOR - FRONT/TRIM PANEL - INSTALLATION)
ADJUSTMENTS
ADJUSTMENT
(1) Remove door trim panel.(Refer to 23 - BODY/
DOOR - FRONT/TRIM PANEL - REMOVAL)
(2) Remove watershield as necessary.
(3) Loosen fastener attaching scissor channel to
door panel at rear of access hole (Fig. 4).
(4) Position glass in run weatherstrips to achieve
smooth operation and proper fit.
(5) Push glass aft and apply slight downward pres-
sure on scissor channel and tighten screw.
(6) Tighten all fasteners.
(7) Install watershield.
(8) Install door trim panel.(Refer to 23 - BODY/
DOOR - FRONT/TRIM PANEL - INSTALLATION)
Fig. 4 FRONT DOOR GLASS ADJUSTMENT
1 - DOOR GLASS ADJUSTMENT POINT
2 - FRONT DOOR
3 - SCISSOR CHANNEL
DOOR - FRONT 23 - 19