Chrysler 300M Service Manual page 1106

LH
COLUMN (Continued)
(25) Remove the 2 screws (Fig. 19) mounting the
ignition switch to the steering column. Remove the
ignition switch, with the wiring harness attached,
from the steering column.
Fig. 19 Ignition Switch Mounting Screws
1 - IGNITION SWITCH
2 - MOUNTING SCREW
3 - STEERING COLUMN
4 - MOUNTING SCREW
5 - MULTIFUNCTION SWITCH
(26) If the vehicle is equipped with a floor
mounted shifter, depress the locking tab on the
shifter/ignition interlock cable (Fig. 20) and remove
the cable from the key lock housing.
Fig. 20 Shifter/Ignition Cable At Lock Cylinder
1 - KEY CYLINDER
2 - LOCKING TAB
3 - SHIFTER IGNITION INTERLOCK CABLE
4 - KEY LOCK HOUSING
Housing
(27) If the vehicle is equipped with a steering col-
umn mounted shift lever, remove the brake transmis-
sion shift interlock (BTSI) solenoid from the shift
lever mechanism (Fig. 21). To do so, perform the fol-
lowing:
(a) Disconnect the wiring harness connector
from the solenoid.
(b) Remove the retainer clip from the end of the
solenoid (Fig. 22).
(c) Slide the solenoid straight off the shift lever
mounting stud.
Fig. 21 BTSI
1 - SHIFT LEVER BRACKET
2 - SOLENOID
3 - KEY CYLINDER
Fig. 22 Solenoid Retainer Clip
1 - SOLENOID
2 - MOUNTING STUD
3 - RETAINER CLIP
COLUMN 19 - 19