Installation; Deck Lid Release Switch Removal; Door Cylinder Lock Switch Removal; Power Locks - Chrysler Concorde 2004 Service Manual

8N - 4

POWER LOCKS

DECK LID RELEASE SOLENOID (Continued)

INSTALLATION

(1) Install the two mounting motor screws and
remote key cable retainers and motor.
(2) Install the cover and latch cover attaching
screws.
(3) Connect and isolate the negative battery cable
remote terminal onto the remote battery post.
(4) Close the deck lid.
DECK LID RELEASE SWITCH
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post.
(2) Remove left lower instrument panel cover.
Refer to Body, Instrument Panel, Instrument Panel
and Pad Assembly, Removal and Installation.
(3) Pinch four tabs around side of decklid release
switch on the rear side of the left lower instrument
panel cover, and push switch through opening.
INSTALLATION
(1) push switch through opening and firmly snap
into place on the left lower instrument panel cover.
(2) Install the left lower instrument panel cover.
Refer to Body, Instrument Panel, Instrument Panel
and Pad Assembly, Removal and Installation.
(3) Connect the negative battery cable remote ter-
minal to the remote battery post.
DOOR CYLINDER LOCK

SWITCH

REMOVAL
(1) Open hood, disconnect and isolate the negative
battery cable remote terminal from the remote bat-
tery post.
(2) Refer to Body, Door - Front, for door trim and
water shield Removal.
(3) Disconnect the wiring clip and pigtail wire con-
nector (Fig. 2).
(4) Remove the Door Cylinder Lock Switch from
door lock cylinder.
INSTALLATION
(1) Install the Door Cylinder Lock Switch onto the
door lock cylinder.
(2) Connect the wiring clip and pigtail wire con-
nector (Fig. 2).
(3) Refer to Body, Door - Front, for Door Trim and
Water Shield Installation.
(4) Connect the negative battery cable remote ter-
minal onto the remote battery post.
Fig. 2 DOOR CYLINDER LOCK SWITCH
1 - DOOR CYLINDER LOCK SWITCH
2 - LOCK CYLINDER
3 - DOOR HANDLE
4 - PIGTAIL CONNECTOR
5 - CLIP

DOOR LOCK MOTOR

DIAGNOSIS AND TESTING - DOOR LOCK

MOTOR

Make certain battery is in normal condition before
circuits are tested.
To determine which motor is faulty, check each
individual door for electrical lock and unlock or dis-
connect the motor connectors one at a time, while
operating the door lock switch. In the event that
none of the motors work, the problem maybe caused
by a shorted motor, a bad switch, or a bad relay. Dis-
connecting a defective motor will allow the others to
work.
To test an individual door lock motor, disconnect
the electrical connector from the motor. To lock the
door, connect a 12 volt power source to the positive
pin of the lock motor and a ground wire to the other
pin (Fig. 3). To unlock the door reverse the wire con-
nections at the motor pin terminals. If these results
are NOT obtained, replace the motor.

DOOR LOCK SWITCH

DIAGNOSIS AND TESTING - DOOR LOCK
SWITCH
VOLTAGE
The following wiring test sequence determines
whether or not voltage is continuous through the
body harness to switch.
(1) Remove left side switch from door trim panel.
LH