Opening The Client - Hand Held Products Dolphin 9500 User Manual

Opening the Client

To access the client the first time, tap Start > Programs > Meetinghouse AEGIS Client.
After the Client has been activated, you can:
1. Tap Start. The icon appears in the quick start tray on the Start menu. Tap the icon to open the Client.
2. Tap the icon in the lower left corner of the command bar.
Icon Indicators
The color of the icon indicates the status of the controlled ports.
Icon Color
Green
Yellow
Red
If there is no yellow, red or green in the icon then either the ports are not being controlled by 802.1X, or there is no
authentication activity on the controlled ports. The absence of yellow, red or green may also indicate that the network
access server is not an 802.1X aware device.
Gray
Orange
Blue
Note: Different parts of the icon can have different colors if more than one interface on the system is running 802.1X. For
example, if your terminal has more than one active network interface card (NIC) then different parts of the icon will have
different colors corresponding to the state of each NIC.
7 - 18
This color icon indicates that ...
Authentication succeeded.
Authentication is in process.
Authentication failed.
The port is not in use or is disabled.
Either the Client isn't running, or the port is not bound to the 802.1X protocol.
The port is associated, but there is no response to 802.11b packets.
If using WEP without 802.1x authentication, this will be the final state when the connection
is complete. If using 802.1x authentication, it is either a transient condition or can indicate
that attempts to authenticate have timed out as there was no response to 802.1X packets.
There is no 802.11b activity. The port may not be connected to an 802.1X-aware entity.
Dolphin® 9500 Series Mobile Computer User's Guide