Hand Held Products Dolphin 9500 User Manual page 153

Profile Info Tab
Field
Network Profile
Network Name
Peer-to-Peer Group
(ad hoc mode):
Do active scan
Authentication Profile
WEP Mgmt Tab
The WEP Mgmt tab enables you to set WEP parameters for each port.
Dolphin® 9500 Series Mobile Computer User's Guide
Description
Enter the name of this record. This is the name that appears in the Configured Networks list and,
by default, is the same as the broadcast SSID. Note that there is nothing special about the name
"default". You could configure any other record similarly and it would behave the same way.
This is the SSID of the access point. If the access point broadcasts its SSID, then this value may
be derived from the Available Networks list. If the SSID does not broadcast, then you must
manually enter the value here.
Select this option to have two or more client workstations communicate with each other without
the benefit of an access point.
You should also select Do Active Scan and, in the WEP Management page, enable Use key
for data encryption while entering a common key for both sides.
WPA is not supported in this mode.
Select this option whenever the access point (or client, for ad hoc mode) is not broadcasting its
SSID.
Select the Client Configuration (user) profile associated with this network. The drop-down list
contains client profile names created in the User tab of the Client Configuration Area; see
Tab on page 7-27.
To open the selected profile, select it in the drop-down list and tap View. The User tab opens
displaying the profile details. If you tap OK (to save changes) or Cancel, you are returned to the
Profile Info tab.
User
7 - 37