Opening The Client - Hand Held Products 7900L00-414C50E - Dolphin 7900 User Manual

Opening the Client

To access the client the first time, tap Start > Programs > Meetinghouse AEGIS Client.
After the Client has been activated, you can tap the icon in the lower left corner of the command bar.
Icon Indicators
The color of the icon indicates the status of the controlled ports.
Icon Color
Green
Yellow
Red
If there is no yellow, red or green in the icon then either the ports are not being controlled by 802.1X, or there is no
authentication activity on the controlled ports. The absence of yellow, red or green may also indicate that the network
access server is not an 802.1X aware device.
Gray
Orange
Blue
9 - 14
Downloaded from www.Manualslib.com
This color icon indicates that ...
Authentication succeeded.
Authentication is in process.
Authentication failed.
The port is not in use or is disabled.
Either the Client isn't running, or the port is not bound to the 802.1X protocol.
The port is associated, but there is no response to 802.11b packets.
If using WEP without 802.1x authentication, this will be the final state when the connection
is complete. If using 802.1x authentication, it is either a transient condition or can indicate
that attempts to authenticate have timed out as there was no response to 802.1X packets.
There is no 802.11b activity. The port may not be connected to an 802.1X-aware entity.
manuals search engine
Rev D Dolphin® 7900 Series User's Guide