The results appear below.
To see specific settings or change a specific setting, tap on one of the tabs, make the change and tap OK to save it.
Remove Programs
The Remove Programs settings enables you to remove programs installed on the terminal. Use this setting to troubleshoot when
you receive messages that the device is out of memory. The programs removed are removed from RAM memory. Any program
(usually *.cab or *.dll files) stored in the Autoinstall folder (My Device > IPSM > Autoinstall) will re-install after the next hard reset.
For information about the Autoinstall process, see
Let Autoinstall Run
on page
2-10.
For information about the hard reset process, see
Hard Reset (Cold Boot)
on page
2-12.
Dolphin® 9500 Series Mobile Computer User's Guide - Preliminary Draft Rev (c)
5 - 15