Check Points Of Every 500 Hours - Kubota V3600-E3 Shop Manual

V3-E3B SERIES, V3-E3CB SERIES, V3-E3BG SERIES, WSM

[5] CHECK POINTS OF EVERY 500 HOURS

Checking Battery Electrolyte Level
1. Check the battery electrolyte level.
2. If the level is below than lower level line (2), and the distilled water
to pour level of each cell.
(1) Upper Level Line
Checking Intake Air Line
1. Check to see if the intake air hose(s) are properly fixed every 250
hours of operation.
2. If the clamp is loose, apply oil to the threads and retighten it
securely.
3. The intake air hose(s) is made of rubber and tends to age. It must
be change every two years. Also change the clamp and tighten
it securely.
IMPORTANT
• To prevent serious damage to the engine, keep out any dust
inside the intake air line.
(1) Intake Air Hose
Changing Engine Oil
[V3800DI-T-E3B, V3800DI-T-E3CB, V3800DI-T-E3BG]
CAUTION
• Be sure to stop engine before changing engine oil.
1. Start and warm up the engine for approx. 5 minutes.
2. Place an oil pan underneath the engine.
3. To drain the used oil, remove the drain plug (1) at the bottom of
the engine and drain the oil completely.
4. Screw the drain plug (1).
5. Fill new oil up to upper line on the dipstick (2).
IMPORTANT
• When using an oil of different maker or viscosity from the
previous one, drain all of the old oil.
• Never mix two different types of oil.
• Engine oil should have properties of API classification CF
(See page G-7).
• Use the proper SAE Engine Oil according to ambient
temperature.
Above 25 °C (77 °F)
0 °C to 25 °C (32 °F to 77 °F)
Below 0 °C (32 °F)
Engine oil capacity
(1) Drain Plug
G-14
G GENERAL
(2) Lower Level Line
W1047154
(2) Clamp
W1029631
SAE 30 or SAE 10W-30
SAE 10W-40
SAE 20 or SAE 10W-30
SAE 10W-40
SAE 10W or SAE 10W-30
SAE 10W-40
13.2 L
3.49 U.S.gals
(2) Dipstick
W1027890