Kubota V3600-E3 Shop Manual page 172

V3-E3B SERIES, V3-E3CB SERIES, V3-E3BG SERIES, WSM
Flywheel Housing
1. Remove the flywheel housing.
(When reassembling)
• Make sure the surface of the crank cases 1, 2 are clean and
alignment between crankcase 1 and 2 is correct.
• Tighten the flywheel housing mounting screws with even force on
the diagonal line.
Flywheel housing
Tightening torque
mounting screw
(1) Flywheel Housing
Crankcase 2
1. Remove the crankcase 2 (1).
(When reassembling)
IMPORTANT
• Make sure the crankcase 1 and 2 are clean.
• Apply liquid gasket (Three Bond 1217D) to the crankcase 2
as shown in the figure.
• Align crankcase 1 and 2 securely.
• Tighten the crankcase 2 mounting screws with even force on
the diagonal line.
• Confirm that the liquid gasket coating surface is free of
water, dust and oil in order to maintain sealing effect.
• Carefully apply the adhesive evenly.
NOTE
• When mounting the adhesive-applied parts, take care to fit
them to the mating parts.
• Assemble the adhesive-applied parts within ten minutes.
Crankcase 2 mounting
Tightening torque
screw
(1) Crankcase 2
S-80
DIESEL ENGINE
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
W1060705
49 to 55 N·m
5.0 to 5.7 kgf·m
37 to 41 lbf·ft
(2) Liquid Gasket
W1060825