Kubota V3600-E3 Shop Manual page 187

V3-E3B SERIES, V3-E3CB SERIES, V3-E3BG SERIES, WSM
Push Rod Alignment
1. Place the push rod on V blocks.
2. Measure the push rod alignment.
3. If the measurement exceeds the allowable limit, replace the push
rod.
Push rod alignment Allowable limit
Oil Clearance between Tappet and Tappet Guide Bore
1. Measure the tappet O.D. with an outside micrometer.
2. Measure the I.D. of the tappet guide bore with a cylinder gauge.
3. Calculate the oil clearance.
4. If the oil clearance exceeds the allowable limit or the tappet is
damaged, replace the tappet.
Factory spec.
Oil clearance between
tappet and guide bore
Allowable limit
Tappet O.D. Factory spec.
Tappet guide bore I.D. Factory spec.
S-95
DIESEL ENGINE
0.25 mm
0.0098 in.
W10292900
0.020 to 0.062 mm
0.00079 to 0.0024 in.
0.07 mm
0.003 in.
23.959 to 23.980 mm
0.94327 to 0.94409 in.
24.000 to 24.021 mm
0.94489 to 0.94570 in.
W1063847