Kubota V3600-E3 Shop Manual page 132

V3-E3B SERIES, V3-E3CB SERIES, V3-E3BG SERIES, WSM
Oil Pressure Switch
1. Disconnect the connector of the oil pressure switch connector
(1P).
2. Check the state of the harness and if it is abnormal, please
replace it.
3. Measure the resistance between the terminal of the connector
(harness side) and chassis.
4. When the measurements are the below table value.
The ECU is normal. The oil pressure switch (1) is failure, then
please replace it.
5. When the measurements are out of the below table value.
The ECU is failure, then please replace it.
Resistance Terminal 1 - Chassis
(1) Oil Pressure Switch
S-40
DIESEL ENGINE
Infinity
W1059711