Kubota V3600-E3 Shop Manual page 173

V3-E3B SERIES, V3-E3CB SERIES, V3-E3BG SERIES, WSM
Aligning Crankcase 1 and Crankcase 2
1. Set the crankcase 2 on the crankcase 1.
2. Tighten the crankcase 2 mounting screws loosely.
3. Set the jig or flywheel housing to the specified torque of the
flywheel housing screw to align the crankcase 1 and the
crankcase 2 (at the flywheel side). Allowable alignment gap
between the crankcase 1 and 2 must be less than 0.05 mm
(0.002 in.)
Crankcase 2 mounting
screw
Tightening torque
Flywheel housing
mounting screw
(1) Crankcase 1
(2) Gap to be smaller than 0.05 mm
(0.002 in.)
(3) Flywheel Housing
S-81
DIESEL ENGINE
49 to 55 N·m
5.0 to 5.7 kgf·m
37 to 41 lbf·ft
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
(4) Crankcase 2
(5) Jig
W1111351