Kubota V3600-E3 Shop Manual page 162

V3-E3B SERIES, V3-E3CB SERIES, V3-E3BG SERIES, WSM
Installing Procedure of Injection Pump Assembly (Continued)
8. Take out the service jig (1).
9. Move the stop lever (6) and visually check to see if the fuel
injection pump control rack comes smoothly back to the start
position by the counter force of the start spring.
10.If the control rack fails to move back smoothly, remove the start
spring and the anti-rotation nut, take the above steps from 2 of
the former page again.
11.Finally fit the sight cover and the solenoid back into place.
Anti-rotation nut
Injection pump mounting
Tightening torque
screw
Injection pump mounting
nut
(1) Service Jig
(2) Governor Connecting Rod
(3) Anti-rotation Nut
(4) Start Spring
(5) Rack Pin
(6) Stop Lever
(7) Sliding Point between Governor Fork
Lever and Governor Connecting Rod
S-70
DIESEL ENGINE
2.8 to 4.0 N·m
0.29 to 0.41 kgf·m
2.1 to 2.9 lbf·ft
24 to 27 N·m
2.4 to 2.8 kgf·m
18 to 20 lbf·ft
18 to 20 N·m
1.8 to 2.1 kgf·m
13 to 15 lbf·ft
[A] V3600-E3B, V3600-T-E3B,
V3600-E3CB, V3600T-E3CB,
V3300-E3BG, V3600-T-E3BG
[B] V3800DI-T-E3B, V3800DI-T-E3CB,
V3800DI-T-E3BG
W1069772