Kubota V3600-E3 Shop Manual page 161

V3-E3B SERIES, V3-E3CB SERIES, V3-E3BG SERIES, WSM
Installing Procedure of Injection Pump Assembly
1. Install the fuel injection pump assembly (1) in the injection pump
unit (2) not to damage governor connecting rod.
2. Slide the governor connecting rod (4) into the rack pin (7) of the
injection pump assembly (1).
3. Place the service jig (3) in the stop solenoid mounting hole /
upper hole of the fuel injection pump unit.
4. Make sure the permanent magnet at the tip of the service jig is
attracted to the governor connecting rod (4). To do this, turn the
jig a little clockwise and counterclockwise and look into the fuel
injection pump unit sight hole to see if the governor connecting
rod (4) moves right and left accordingly.
5. Slightly tighten the anti-rotation nut of the governor connecting
rod.
6. Holding down the service jig (3) by hand, tighten the anti-rotation
nut (5) to the specified torque.
7. Hook the start spring (6) to the rack pin (7).
(1) Fuel Injection Pump Assembly
(2) Fuel Injection Pump Unit
(3) Service Jig
(4) Governor Connecting Rod
S-69
DIESEL ENGINE
(5) Anti-rotation Nut
(6) Start Spring
(7) Rack Pin
W1069371