Kubota V3600-E3 Shop Manual page 168

V3-E3B SERIES, V3-E3CB SERIES, V3-E3BG SERIES, WSM
Connecting Rod Cap
1. Remove the connecting rod screws (1) from connecting rod cap.
2. Remove the connecting rod caps.
(When reassembling)
• Align the marks (a) with each other. (Face the marks toward the
injection pump.)
• Apply engine oil to the connecting rod screws and lightly screw it
in by hand, then tighten it to the specified torque.
If the connecting rod screw won't be screwed in smoothly, clean
the threads.
If the connecting rod screw is still hard to screw in, replace it.
• When using the existing crank pin metal again, put tally marks on
the crank pin metal and the connecting rod in order to keep their
positioning.
Tightening torque Connecting rod screw
(1) Connecting Rod Screw
S-76
DIESEL ENGINE
79 to 83 N·m
8.0 to 8.5 kgf·m
58 to 61 lbf·ft
(a) Mark
W1058252