Kubota V3600-E3 Shop Manual page 165

V3-E3B SERIES, V3-E3CB SERIES, V3-E3BG SERIES, WSM
Relief Valve
1. Remove the relief valve retaining screw (1).
2. Remove the relief valve (2), the spring (3) and the packing (4).
Relief valve retaining
Tightening torque
screw
(1) Relief Valve Retaining Screw
(2) Relief Valve
Idle Gear and Camshaft
1. Remove three set screws of the idle gear and draw out the idle
gear 1, 2.
2. Remove two set screws of the camshaft stopper and draw out the
camshaft.
(When reassembling)
• Set the crankshaft at the top dead center of No. 1 and 4 cylinder
and the camshaft key to the top position and align the marks of
idle gear 1 (3) and idle gear 2 (2) to assemble them. (Refer to the
figure on the left.)
• Mount the injection pump gear (1) after installing the gear case.
Camshaft set screw
Tightening torque
Idle gear mounting screw
(1) Injection Pump Gear
(2) Idle Gear 2
(3) Idle Gear 1
(4) Cam Gear
(5) Crank Gear
S-73
DIESEL ENGINE
69 to 78 N·m
7.0 to 8.0 kgf·m
51 to 57 lbf·ft
(3) Spring
(4) Packing
W1081251
24 to 27 N·m
2.4 to 2.8 kgf·m
18 to 20 lbf·ft
24 to 27 N·m
2.4 to 2.8 kgf·m
18 to 20 lbf·ft
[A] V3600-E3B, V3600-T-E3B,
V3800DI-T-E3B, V3300-E3BG,
V3600-T-E3BG, V3800DI-T-E3BG
[B] V3600-E3CB, V3600-T-E3CB,
V3800DI-T-E3CB
W1189797