Kubota V3600-E3 Shop Manual page 177

V3-E3B SERIES, V3-E3CB SERIES, V3-E3BG SERIES, WSM
Reassembling the Brush
1. Fit the brush with its sliding face in the clockwise direction when
viewed from front.
IMPORTANT
• Be sure to keep the 2 brushes deep in the brush holder.
Otherwise the rotor and the rear section can not be fitted
into the position.
• Use a 4 mm hex. wrench to push the brushes into place.
• Using a pin-pointed (2 mm) punch, keep the brushes from
popping out.
2. Match the tally line of the front section with that of the rear
section.
3. Tighten the 4 screws.
4. Draw out the pin-pointed punch out of the brush holder.
(1) Marking
Bearing at Slip Ring Side
1. Lightly secure the rotor (1) with a vise to prevent damage.
2. Remove the bearing (2) with a puller (3).
(1) Rotor
(2) Bearing
S-85
DIESEL ENGINE
W1075117
(3) Puller
W1019701